![Image](http://img.photobucket.com/albums/v625/derangedsheep/pel02a.jpg)
Sorry about the watermark, I pulled it from the website at work. It's a limited slip from Peloquin's.
And while it was up on the lift I put on the rear swaybar I picked up at the end of the summer, two days before I went back to school. It's a Neuspeed 28mm solid bar.
![Image](http://img.photobucket.com/albums/v625/derangedsheep/Swaybar.jpg)
It's kinda grainy because I left my camera at my apartment so I had to use my phone. You can also sorta see the suspension too. It's a Weitec 60/40 cup kit.
Here's a side shot for fun.
![Image](http://img.photobucket.com/albums/v625/derangedsheep/Side_Shot.jpg)
And because I ran across it on my computer, here is a scan of my dyno run from last summer (179.85HP 206.08TQ). Since then I added a cold air intake. Even though it's probably only good for 3HP or so, it sounds sweet.
![Image](http://img.photobucket.com/albums/v625/derangedsheep/Dyno_Scan.jpg)