EGR tube gaskets for 2p8

[The Dark Side of Will]

I need the gaskets that seal the EGR tube to the manifold & EGR valve. CarQuest doesn't have them listed as such, although they may be in the EGR valve gasket set.

Anybody know where I could get these? Fierostore?

[Shaun41178(2)]

I do know they come in the intake gasket kit from felpro. Its like $25 but kind of pricey if you only need the egr stuff. I might have some laying around. If so I can slap a stamp on an envelope.

[The Dark Side of Will]

If you have a couple, that would be good.

The Fierostore has them for $3.50 each.
I'm going to check Advance & Autozone today.

[rube]

You could just get some copper flashing and cut your own.

[The Dark Side of Will]

Car's not urgent. I'll save the creativity for engine swaps.

[Series8217]

2p8? Time for an engine swap.

[The Dark Side of Will]

Looking at 3.0 TDC, but have to build the engine first and don't have pistons/rings yet.

[Shaun41178(2)]

don't know if the 2.8 egr gaskets will work. Not sure if they are the same as the TDC gaskets. If thats what you need them for is a TDC then I prob can't help ya.

[The Dark Side of Will]

No, need them for 2p8.

[MNFatz]

Summit stocks exhaust gasket material sheets. Something like $5 for a sheet 12 by 12 inch square.

Of course you'll have to find something else to buy--the handling charge will be more than the purchase.

edit: Here's the part number: PHP-68006. unfortunately it looks like they're out of stock until 9/15.

[Shaun41178(2)]

ok then yea I have a set for the 2.8 The metal one for down at the valve, and a paper one for the intake mani. Felpro peices

[rube]

Car's not urgent. I'll save the creativity for engine swaps

Copper sheet, a pair of snips and a couple of hole punches is creative? OK.