Help with TPS activation switch install?

goatnipples2002 · Post by **goatnipples2002** » Fri Mar 30, 2007 6:24 pm

Which wire do I connect to, the blue TPS signal wire or the gray 5+ volt? or better yet which one is the TPS output wire?

Shaun41178(2) · Post by **Shaun41178(2)** » Fri Mar 30, 2007 6:51 pm

Where is your instruction manual?

whipped · Post by **whipped** » Fri Mar 30, 2007 7:13 pm

signal = output

p8ntman442 · Post by **p8ntman442** » Fri Mar 30, 2007 8:35 pm

I replyed to your thread on OE. Get a fucking manual (available online for free) and look up the wiring diagram. Its the TPS output wire so if you have a volt meter just check which one changes voltage with TPS location change.

People should need a liscense to work on their cars.

Chris-Nelson · Post by **Chris-Nelson** » Fri Mar 30, 2007 11:29 pm

p8ntman442 wrote: People should need a liscense to work on their cars.

lol

cactus bastard · Post by **cactus bastard** » Sat Mar 31, 2007 1:22 am

I lol'd a bit at that too.

goatnipples2002 · Post by **goatnipples2002** » Sat Mar 31, 2007 2:35 am

I don't have volt meter and fuck you. Thanks for the help.

Dirty Sanchez · Post by **Dirty Sanchez** » Sat Mar 31, 2007 10:10 am

Grey wire is 5 volt reference, dark blue wire is TPS signal, and black is ground. You use the dark blue one. :thumbleft:

The Dark Side of Will · Sat Apr 07, 2007 1:11 am

goatnipples2002 wrote:I don't have volt meter and fuck you. Thanks for the help.

Fuck you too. Get a test light. Don't bitch at us because you don't have the right tools for the job.