Page 1 of 1
Lumina 3.4 - what trans
Posted: Tue Dec 12, 2006 1:27 am
by Tha Driver
:salute:
sayonara
Posted: Tue Dec 12, 2006 2:21 am
by Series8217
It's a 4T60E and unless it has zero miles on the drivetrain its not worth anything close to $2500.
Posted: Tue Dec 12, 2006 2:35 am
by Tha Driver
:salute:
sayonara
Posted: Tue Dec 12, 2006 4:13 am
by Series8217
Used complete motor $800 - $1200 depending on mileage (if its over 50,000 its not worth more than $800 IMO).
Keep in mind crate motors pop up on ebay a lot for $900-$1200. Then one just needs a $100 pick-a-part motor for the manifolds and missing accessories and they have a complete engine with zero miles on the mechanical bits.
Not sure what the 4T60Es are going for...
Posted: Tue Dec 12, 2006 1:58 pm
by Tha Driver
:salute:
sayonara
Posted: Tue Dec 12, 2006 4:22 pm
by Series8217
Tha Driver wrote:What about the wiring & electronics?
I was including that
Posted: Tue Dec 12, 2006 4:31 pm
by Tha Driver
:salute:
sayonara
Posted: Tue Dec 12, 2006 4:48 pm
by Series8217
Tha Driver wrote:OK thanks again.
Did you roll the car in your avatar? Not a good way to stop a Fiero....
No, just flew it over things and did cartwheels.
Posted: Tue Dec 12, 2006 4:55 pm
by Tha Driver
:salute:
sayonara
Posted: Tue Dec 12, 2006 5:23 pm
by Mach10
Is the 283 fuel injected? Because you won't see a whole lot of use out of an electronically controlled transmission without an accompanying ecm. :salute:
Posted: Tue Dec 12, 2006 6:10 pm
by Series8217
Mach10 wrote:Is the 283 fuel injected? Because you won't see a whole lot of use out of an electronically controlled transmission without an accompanying ecm. :salute:
He said paddle shifters. That means whipped's transmission controller.