Lol... step by step.
Alternator is wired up in the "hybrid" config FieroGuru did. That config sends the sense wire to the electrical center as in the Corvette, the F wire to the ECM as in the Corvette and the L wire to both the ECM as in the Corvette *AND* the dash light as in the original Fiero system. I was going to wire both L-terminal connections with 22ga TAN, but I ran out of that and stole some 22ga WHT for the stock Fiero lamp connection at C500. I was literally only about 8 inches short in the last piece on my tan wire spool.
I do not yet have the cable seal, but I have a couple of leads for different configurations of the cable seal for applications using different terminals. I may harvest one from a junk yard as well.
The MAF sensor is wired up... except for TAN 22ga. Need to order a little more of that.
I would have wired up the DBW and been very close to complete with items on the engine that the main harness connects to, but I realized I did not have the wire seals for the DBW connector. The STS throttle I'm using is weird in that it is connectorized for a TE Connectivity MQS family connector. Weird.
Order from ProWire with next batch of shrink tube is not here yet, so I've made as much progress as I can for the day. There are a couple of bolts and spacers for the engine mount bracketry that I need to dig up, as well as some small P-clamps I should have around someplace and now need for securing the coil pack connectors on the main harness.
Harness list:
-16GA BLK for bank 2 coil pack connector when backorder arrives
-22ga TAN for IAT signal wire when my next harness order arrives
-DBW wiring when I get the wire seals
-HO2S when I get manifolds back from cerakoting
-VSS & backup lights after I pull the engine off the stand to bolt up the transmission
-Canister vent & purge connections once I get the powertrain in the car and pick a canister
Samco now has a product line suitable for pure pressurized gasoline and it is available in red
They can also make hose lengths longer than 1 meter, but via special order. My heater hoses have to be longer than 1m, but I need to measure exactly how long.
I have a whole raft of bits and bobs of body and engine compartment prep I can get done over Labor Day weekend... <3 Progress